• The steering guide must be installed after a long, free-entering web span to prevent wrinkling. A web entry span of at least 2x the maximum web width must be maintained.
• The pre-entry span must be shorter than the entry span.
• The preferred exit span should be at least 1/2 to 1x the maximum web width.
• The air-flow sensor must be securely mounted after the guide's exit roller (within the first 1/3 of the exit span).
• At least one idler roller must be located between the exit roller and the process (i.e. printing) to avoid guiding directly into a process.

• Wash Down
• Dusty Dirty
• High Heat
• Clean Room
• High Humidity
• Explosion-Proof

Web Path Configurations

Guides can be placed in any orientation and the sensor can be on either the near side or far side of the web. Dual sensor to center-guide is optional.

How to Specify

• Center Guide
• Splice Table
• Stainless Steel
• Multiple Stack Units
• Remote Sensor Controls

We no longer provide downloadable drawings. Please use this form to speak with a rep about providing the most accurate drawing for your needs.